• Warm water is recommended
• Powder should be full dissolved in water prior to use

1. Remove any solids or debris from the surface.
2. Spray as necessary to completely coat the surface(s) with Stera-Sheen Green Label solution.
3. Brush clean and/or wipe with clean towel until visibly clean.

1. Remove any solids or debris from the surface.
2. Spray as necessary to completely coat the surface with Stera-Sheen Green Label solution.
3. Allow to soak for at least 60 seconds.
4. Use clean towel to remove excess solution or to dry.

1. Saturate a clean towel or dip a brush in Stera-Sheen Green Label solution.
2. Brush and/or wipe until surface is visibly clean.

1. Using a clean towel completely coat the surface with Stera-Sheen solution.
2. Allow to soak for at least 60 seconds.
3. Use clean towel to remove excess solution or to dry.

• Spray bottle should be indicated for use with Stera-Sheen Green Label Sanitizer & Cleaner solution only. Do not use or mix spray bottle with any other chemicals.
• After 4 hours, Stera-Sheen Green Label Sanitizer & Cleaner solution should be retested to indicate available chlorine per your local health department requirements, or the solution should be discarded. Mix new solution as needed following the correct dilution ratio.

**At the present time, no current product is EPA-registered as a virucide specific to the novel coronavirus, and Purdy Products makes no representation that control of COVID-19 is certified by US EPA.